-1 dbA egenstøy!

Varenr: LCT 540 S-LW
6 396,-eks. mva
Logg inn for å se dine nettopriser.
Ikke kunde? Søk om forhandlerstatus.
4 på lager i Oslo
BeskrivelseLenker & dokumenter

The engineering of this particular piece of cutting-edge audio technology asked for a forward-thinking approach towards capsule and circuit design. As a result, a way of experiencing sound at infinite depth and absolute precision came to life; its name, the LCT 540 SUBZERO. Get involved with tone and sound in ways unheard and bring your recordings to perfection by capturing all the fine-grained characteristics that constitute each moment of your performance. Rediscover your instrument and voice on a whole new level of musical detail.

To see how good our hearing is in a purely technical way we can look at the threshold of hearing. Bear in mind that our hearing threshold is very frequency dependent. Human hearing is less sensitive towards low and very high frequencies and most sensitive around 2 – 5 kHz. Comparing the hearing threshold to the self-noise values of the LCT 540 SUBZERO, you can clearly see that our microphone is always below the threshold of hearing. To look at the self-noise of a microphone in a single value is just not detailed enough when discussing high-end sound transducers.

When you climb a mountain, and the weather is clear, your reward is a fantastic view. If it is partly cloudy or foggy, the payoff is profoundly reduced. The same goes for recording. Some peaks stick out of the noise floor (fog), but if you remove as much noise as possible, you will be rewarded with details that were buried before. This microphone can pick up the subtlest details in vocals or instruments, an almost inaudible whispering can be pushed up and sound crystal clear. Many noise issues only reveal themselves in post-production. Once you start compressing the signals a previously inaudible noise floor can appear; not with the LCT 540 SUBZERO.


Acoustical operating principle: Pressure gradient transducer, externally polarized
Diaphragm: 3 micron gold sputtered Mylar
Transducer Ø: 25.4 mm, 1 in
Polar pattern: Cardioid
Sensitivity: 41 mV/Pa, -28 dBV/Pa
Equivalent noise level: 4 dB (A)
Max. SPL for 0.5 % THD: 136
Signal / noise ratio: 90 dB (A)
Dynamic range: 132 dB (A)
Pre-attenuation pad:  0 dB, -6 dB, -12 dB
Low-cut filter: linear , 80 Hz (6 dB/oct), 160 Hz (6 dB/oct)
Internal impedance: 68 O
Supply voltage: 48 V +/- 4 V
Current consumption: 3.6 mA
Mic enclosure: Zinc die cast
Connector: Gold plated 3-pin XLR
Microphone dimensions: 158 x 52 x 36 mm, 6.22 x 2.04 x 1.42 in
Microphone net weight: 371 g, 13.1 oz

Lenker & dokumenter
Varen er på lager.
Varen er bestilt fra leverandør og leveringsdato er bekreftet.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varen må bestilles fra leverandør.
Varen befinner seg på fjernlager.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varene bestilles fra vår leverandørs lager.
Ubekreftet - Ta kontakt med kundesenter for nærmere informasjon.